New Vident iLink 400 tester Full System car scan Tool For ABS / SRS / EPB / DPF Regeneration/Oil Reset Update Online

1. Engine System: Quickly judge the cause of the engine system and turn off the warning light. It also retrieves current,
permanent and pending codes in the vehicle’s engine system.

2. ABS System: When you see the ABS (Anti-lock Brake System) light on, you know it’s serious. Just plug the device into your 16-pin port (usually under your steering wheel) and use it to figure out what’s wrong. You can determine what might be causing the error: low brake fluid, a blown fuse, or an unusual signal from a wheel sensor.

3. SRS (Airbag) System: When the SRS (safety restraint system) light comes on, it means that the airbag control unit has detected a problem with the system. You can use iLink400 to check the SRS system for faults and repair them. It is very important that the airbags work properly at all times.

4. Transmission System: If you notice any of the following: slipping transmission, jerky shifts, engagement delays, fluid leaks, or transmission warnings, your car may need service. You can use the iLink400 to perform a range of diagnostics and pinpoint problem areas for repair.

more…

1. Read their ECU version numbers of the tested control units.

2. Read & erase DTCs to locate trouble areas and clear the codes.

3. View Live Data of each parameter item.

4. Capable of advanced functions: Active Test, Actuation, Activation, Adaptation, Initialization, Learn/Relearn, Adjustment and Coding.

1. Fuel Pump Tests
2. Cooling Fan Tests
3. A/C Clutch On/Off Test
4. ABS Motor Pump Test
5. Car Wipers
6. Window/Door/Sunroof/Wipers Tests
7. Sound Horn Test
8. Interior Lighting Test
9. EVAP Tests

By directly monitoring their operations, you can quickly locate the problems and solve them.

2. Electronic Parking Brake (EPB) Service: Allows you to perform service and maintenance, including deactivation and activation of brake control system, bleeding brake fluid, opening and closing brake pads, and setting brakes after disc or pad replacement, on where electronic brake systems are fitted. Diagnoses EPB caliper functionality, initializes the wear indicator if new pads installed and deactivates or re-activates brake control system.

3. Steering Angle Sensor (SAS) Calibration: Allows you to perform calibration of the steering angle sensor, which permanently stores the current steering wheel position as straight-ahead in the sensor EEPROM. After calibrate sensor successfully, its fault memory will be automatically cleared.

4. Battery Registration: When you change a new battery, you need to register the battery information, iLink400 can do it easily.

5. Throttle Adaptation: After clearing or repairing the electronic throttle, re-learning and adapt throttle sensor position is
necessary to precisely adjust the throttle opening.

6. Special Function of Diesel Engine: Specially works for Diesel Particulate Filter system with DPF regeneration, DPF component replacement teach-in and DPF teach-in after replacing engine control unit.

7. Read Anti-theft Code: Programs a new anti-theft key, and performs key matching when the ignition switch, the combined instrument panel, ECU, BCM, or the remote control battery is replaced.

8. Reset Airbag: Allows you to have a deep analysis and detection for your vehicle via read fault codes. But sometimes the permanent fault codes in this system will still appear and the warning light flashes after the airbag replacement. Then you will need this SRS scan tool again to turn the light of

2. Remove the TF card from your turned off tool and connect it to the PC via an TF card reader.

3. Once Windows has detected the TF card, run the iScanzilla software and login again. click the ‘My Updates’ button.

4. Click the Update button to download and install available updates.